Results 1 to 5 of 5

Thread: FCU indication

  1. #1
    150+ Forum Groupie pdpo's Avatar
    Join Date
    Nov 2005
    Location
    belgium
    Posts
    260
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    FCU indication

    To any (friendly) airbus pilot,

    could someone tell me the working of following annunciators on the FCU display :
    LAT indication
    ALT indication
    LVL/CH indication

    HDG or TRK indication
    VS or FPA indication

    The question really is when do they become active and more when do they go off

    In many videos i have seen taken in the cockpit the HDG and V/S are always on when HDG/VS (middle indicator) is on and
    the TRK and FPA are on when TRK/FPA button is pressed and the TRK/FPA indicator (middle indicator) is on .
    I mean HDG and VS or TRK and FPA are on depending on the system used on the FCU.
    Is this correct or are there other situations that can turn them off or on?
    LAT indication seems to be always on ?
    LVL/CH seems to be always on ?
    ALT indication seems to be always on ?

    Greetz Peter
    Belgium

    PS : difficult to explain without proper picture
    PS : the reason of asking is that Project Magenta software switches the LVLCH only on when climbing to new altitude
    or descending
    ALT indication on only when target altitude is reached
    V/S indication only on when climbing/descending in V/S mode (not in open climb, open descent, managed descent, managed climb)
    HDG always on when not in TRK/FPA mode
    LAT always on

  2. #2
    MyCockpit Support Staff dodiano's Avatar
    Join Date
    Oct 2005
    Location
    El Salvador
    Posts
    930
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Ok Will try to answer this:



    First of all LAT Indication, ALT indication and LVL/CH Indication they never change they are basically Indicators that reflect the functions on that specific window of the FCU... The only ones that change are when you press the spd/mach swithc that you change the window indication from SPEED TO MACH or vice Versa you see it shown on the left side of the FCU window and the dial change from 3 digit number to a 0.XX number when pressed!

    On the HDG window it only changes from HDG to TRK when you press the TRK/FPA switch and also the center window indication will turn to TRK/FPA which will be lateral and vertical modes you have selected!

    The other that will change is the indication on the VS window Right portion of the FCU window will go to Degrees and will turn to FPA if I recall correctly and it will appear as degrees not longer as feet per minute!

    Now the use of TRK/FPA is not an easy one! Basically you never take off TRK/FPA cause you use heading to fly assigned headings by ATC now TRK is used when you are flying a Track for example when intercepting a Radial on a VOR approach where the plane centers towards a signal and makes corrections according to wind to keep that one centered! Now the HDG doesn´t do this you basically follow a heading but the wind could be kicking you out of the desired Track although you have the correct Heading! Also you get the Birdie out which is an amazing tool for flying Visual approaches and is a must for VOR approaches!

    Hope this helps!

    Roberto

  3. #3
    MyCockpit Support Staff dodiano's Avatar
    Join Date
    Oct 2005
    Location
    El Salvador
    Posts
    930
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Oh and one more Thing V/S Indication will be on dashes on Open Descent and Descent the plane uses speed to make a descent also a climb it will never appear V/S Unless you select it or you have a mode reverssion to vertical speed.

    Regards,

    Roberto

  4. #4
    Executive Vice President, MyCockpit


    Matt Olieman's Avatar
    Join Date
    Oct 2005
    Location
    Ocala, FL USA
    Posts
    2,884
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Roberto, Excellent explanation. It's nice to have fellow builders, particulary real pilots help the rest of us dreamers

    Thank You Roberto

  5. #5
    150+ Forum Groupie pdpo's Avatar
    Join Date
    Nov 2005
    Location
    belgium
    Posts
    260
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Well Matt,

    I couldnt have put it better.....we are so lucky we got someone like Roberto to answer these kind of questions
    At least we can get our simulated world and hardware closer to reality in this way.

    Thanks a thousand times Roberto

    Peter
    Belgium

Similar Threads

  1. YD indication on PFD problem
    By dcutugno in forum PM General Q & A
    Replies: 10
    Last Post: 02-05-2007, 12:16 PM
  2. TAT indication
    By George Papanikolopoulos in forum PM General Q & A
    Replies: 1
    Last Post: 02-12-2006, 06:27 AM
  3. Re: Flap Indication
    By Katy Pluta in forum PM General Q & A
    Replies: 0
    Last Post: 02-05-2005, 07:41 PM