First look and some help needed.

[Niklas]

Hi,
First make sure that you run Widefmgs client with the serverip on your second pc.
Second do you run fmgs server and widefmgs server on the main pc?
Third, do you start with external power? Is all pwr incl external on an BUS TIE not OFF?

[asessa]

Hi,
First make sure that you run Widefmgs client with the serverip on your second pc.
Second do you run fmgs server and widefmgs server on the main pc?
Third, do you start with external power? Is all pwr incl external on an BUS TIE not OFF?

1.yes it's correct (you can see right ip address into log i reported)
2.yes they run
3.yes!

[jeehell]

Hi,

Check there is no firewall or antivirus issue.
Check you run the software with admin privileges.

REgards,
JL

[asessa]

Hi,

Check there is no firewall or antivirus issue.
Check you run the software with admin privileges.

REgards,
JL

Hi JH , i have firewall stopped on both pc.
The server pc run with Win10 Pro 64bit with windows defender active
The clien pc run with Win7 Ultimate 64bit and Microsoft Essential Security

Both FMGS run with admin privileges.

[jeehell]

it isbetter to have the firewall with program exceptions. windows security software may also block ports etc...

[asessa]

it isbetter to have the firewall with program exceptions. windows security software may also block ports etc...

Uhm ok i'll try to shutdown all security software.
Do i need to install any sdk (fs,p3d or other) on client pc?

[asessa]

Another thing... when i start FGMS on client pc , some stby instruments like Altimeter and SpeedIndicator should be turned on...(triple fuel is on)... why are this stby turned off ??

[jeehell]

Hello,

you don't need to install any sdk. The installer has all the required files with it.
Did you change any of the default ports?
How do you run the software? Using the starter?
You did NOT install the FMGS Server on the client computers?
Can you try to ping the server IP from the client?
(you can do it in the cmd line: ping 192.168.1.114 )


JL

[asessa]

Hello,

you don't need to install any sdk. The installer has all the required files with it.

Ok

Did you change any of the default ports?

No, i leave all default values

How do you run the software? Using the starter?

Yes i use the starter with "run as admnistrator"

You did NOT install the FMGS Server on the client computers?

FGMS Server is not istalled

Can you try to ping the server IP from the client?
(you can do it in the cmd line: ping 192.168.1.114 )
JL

Yes it ping server

[jeehell]

I would really turn back on the windows firewall. Then go to the firewall settings, look for program exceptions. There, delete the exceptions which may be already existing for widefmgs, widefmgsserver, etc. and add them again manually.