A320 FMGS B31

[jeehell]

Do you use FSX or FS9?
If you use FSX, do you use StarterFSX.exe or starter.exe?

JL

[jeehell]

And by the way, the tiller WILL NOT move the rudder on the SD F/CTL page. You must test during taxi at slow speed.

[Leonidas]

And by the way, the tiller WILL NOT move the rudder on the SD F/CTL page. You must test during taxi at slow speed.

I'm using P3D and I've tested it that way. I'll do the configuration again. Thanks for all.
Regards

[OmniAtlas]

Hi there -- aircraft is still pretty unstable in flight and on approach.

I am using the default AC included in the Jeehell package (pa320-cfm56-2.air). Do I also have to change the coefficients or are the config files in the FMGS Server\PREF\PA320 sufficient?

Also, I still get 'terrain terrain' warnings even though approach mode has been activated and for some reason even though I am in managed mode the aircraft does not want to idle the engines to decrease speed. I end up doing a CATIII landing at 200+.

[OmniAtlas]

The config files in FMGS SERVER\Perf\ is under the directory "PA320"

Should I rename to iFDGA320 ?

[jeehell]

Hi,

DO NOT, EVER, change any PERF file or else, unless you know exactly what you do.
There may be some issues but you will only mess things more. The nalme is not an issue.

I personnally do not have any stability issue at low speeds. Check that you have 30 fps or more in FS. Also check your weight is not too big (around 65t is good).
As for speed reduction, never trust the computed vertical profile, and start reducing yourself.

Regards,
JL

[Space]

@ OMNI Atlas:
i do have exactly the Same Problems. Check the unstable flathering Rudders with the ECAM display, you can see it there. I am flying with 20% fuel and correct Speed and flaps.

Don't know why.

[OmniAtlas]

I think it maybe an autopilot problem -- I've checked my joystick and rudder settings and they are fine.

[Leonidas]

Do you use FSX or FS9?
If you use FSX, do you use StarterFSX.exe or starter.exe?
JL

I deleted 2 joystick conf files, run Windows calibration, then FMGS_Config and save the all new configuration. Everything seems OK until now, but when I run P3D (with disabled controllers) and JeeHell with AS-NWS ON, tiller doesn't turn the AC. Rudder works normally. I don't know what else I should see. Maybe is a P3D issue...
Regards

[filippoporcari]

i have NO stability problems at all...must be a local problem.

@ JL: i'm doing my first flights on ivao after the switchover...everything seems correct with ivao (transponder code, mode, tcas) just having no response on the IDENT function. i'm using skalarki pedestal and the ident button is properly assigned to ident.
pushing the ident button does not triggers the ivao ident: skalarki problem or fmgs?
cheers
fil