737ng Oxygen mask panel+++++

[phil744]

Sounds like a challenge for Phil (phil744)!!!

Is this going to be one of those "challenge Phil" moments again?

[DAL900]

Phil,
I have 2 real ones if you need measurements

[ivar hestnes]

Actually thanks for the photo Ivar. Just what the Doctor needed to be able to reproduce such a thing.

Thanks a bunch...

Measurements here





Someone start making replicas right away


Lots of talking in this thread, but still no goodies for me. At least we are having fun, while I suffer in need of rare parts

[vidarf]

Yeah, you're reeeeeeaaaaaally suffering there, Ivar. Really! I am sooo sorry for you...

[Trevor Hale]

IVAR!!

You list 14mm in the one measurement, and 18mm in the other, is that a Type O?

Trev

[737NUT]

I'd like to be able to make interior panels.

Though I don't think I'd be too good at making molds for the vacu-forming process.

You can get the REAL stuff cheap for the 727. I got a complete set for 300.00!!!

[ivar hestnes]

IVAR!!

You list 14mm in the one measurement, and 18mm in the other, is that a Type O?

Trev

Yep, thats a typo. Probably 14 that is correct. 18 would be wrong since it would not be enough space for the Dzus then

And Vidar. Yes I am suffering All of us 737 builders suffer until we can have these parts (But I am smiling all day long now Vidar. Bet you know why, hehe). Will smile for several months

I want it all, hehe Please someone ship me a complete aircraft

It would be very nice with original oxy panels. But repro will do

[Michael Carter]

You can get the REAL stuff cheap for the 727. I got a complete set for 300.00!!!

If you can find it. I've been after Nick for six mobths for an eyebrow trim panel. I have a piece of ceiling panel on the way from Bill (batcat) that goes above the eyebrow trim, but that's aboout all I've seen lately.

[nihad]

Hi everybody,


I was following up with tis link and this evening I got my hand on a unit so I could check out if I could copy it and it is possible ,like I said had the unit in my hands and unscrewd the 2 latches to see what and how to do it. So for those interested I can copy the 2 top latches from both sides and also the smaller parts attached to it as the rest is just a container that holds the oxygen mask which by the way is obviously not a thing that can be copied.
The only thing is that I am only able to do so if there is enough interest in these units so for a couple it wont be realistic to make 4 moulds and also way too expensive but if there is enough interest the possebility is there.
please let me know again for those that are interested.
Thank you

Nihad

[dnoize]

well I for one would be interested nihad !

Stef