Results 1 to 3 of 3
  1. 10-08-2009, 01:41 PM #1
    bagarie
    bagarie is offline
    25+ Posting Member
    Join Date
    Feb 2008
    Location
    Italy
    Posts
    70
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    TQ simulatory issue

    Hi to all.

    I've just bought a TQ Simulatory from a my friend. I changed the Fsbus interface with the Leo Bodnar interface to better use with Fsuipc. But I have a problem with the Thrust lever N2 potentiometer. It give not smooth value like the N1.
    exemple: In Fsuipc calibration page, I see values change from -16383 to 0 suddenly with no intermediate values like the potentiometer for thrust N1.

    Do you know how to disassembly the TQ in order to change the potentiometer?

    Many thanks and sorry for my bad english.

    Arnaldo Vacca
    Reply With Quote Reply With Quote
  2. 10-08-2009, 05:42 PM #2
    mpl330
    mpl330 is offline
    300+ Forum Addict mpl330's Avatar
    Join Date
    Mar 2007
    Location
    Yorkshire - UK
    Posts
    481
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: TQ simulatory issue

    I shall watch this thread with interest as I need to do this too
    Was it easy to remove fsbus and replace with the Leo card?

    Cheers
    Mike
    Reply With Quote Reply With Quote
  3. 10-09-2009, 02:18 AM #3
    ian@737ng.co.uk
    ian@737ng.co.uk is offline
    500+ This must be a daytime job
    Builder Of The Month / Point Value: 100
    Total Awards: 1
    Total Points: 100
    ian@737ng.co.uk's Avatar
    Join Date
    Jan 2006
    Location
    Oswestry, Shropshire
    Posts
    604
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: TQ simulatory issue

    mike,
    it's not difficult if you have 16 pin IDC plug connecting the switches & pots to your control board. there's a wiring diagram on my website and if you need, i'll walk you thru it.
    i've done it a couple of times for colleagues.

    rgds ... ian
    Mr. Ian. P. Sissons is hereby recognised as an Honorary Flight Sim Captain following his passing in February 2016. This is in recognition for his commitment to Flight Simulation.

    www.mycockpit.org Featured Builder August 2008 www.737ng.co.uk
    FS9/PROSIM737/CPFLIGHT/Lots of BU0836X's and a Beer Fridge
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Elevator issue
    By Soufiane in forum JeeHell Ware Q&A and Discussions
    Replies: 3
    Last Post: 04-18-2010, 01:43 PM
  2. simulatory front and aft overhead for sale
    By jeroen in forum Cockpit Parts and Motion Platforms
    Replies: 4
    Last Post: 12-10-2008, 11:57 AM
  3. FSUIPC issue?
    By DENNIS ORSAG in forum General Builder Questions All Aircraft Types
    Replies: 4
    Last Post: 03-30-2008, 10:50 AM