korry switches.

[Michael Carter]

387's are rated at 7,000 hours. You could likely get 10,000 using 24VDC. Of course that depends on how old they are now.

[CocnutAir]

David,

I use 28V power supply with Phidget 16/16. Works fine.
You may want to open up Korrys, in any event, to clean up the bulb contacts. These sometimes carry a bit of oxidation from over the years.
May give intermittent illumination outage that are hard to track down.

Regards,
Alan

[LH784]

I use Opencockpit USB output cards with 24 V and they work really well. Since you only need the card and the power supply, that might be the chioce. However, unless I made mistakes with identifying the connections, I think that that will put the whole Korry under 24V, so if you want to use the push-switch in order to turn it off (e.g. master caution etc) that might burn your inputs card if it only uses 5V (until now I have never tried, but I think it is that way).
Greetings, Florian

[David Withers]

i have a bunch of phidgets cards..so ill go with those.

do most people use fs offsets and plug them into fs2 phidget to get mip lights/switches going?
or is there a hidden file somewhere?

[gokhotit]

I use fs offsets with my phidgets, all simplified by FS2Phidgets (props (or jets) to Allen). All very simple. Power to light, ground to phidget 16/16, voila. FS2Phidgets does the rest.

[767300]

Hi guys,

I have different Korrys and some have serial numbers and diagrams etc, but I have a few that are shorter and have a split legend possibly for Caution Master Caution. These are the numbers on that are on them.
TOP
KORRY
81590 9711
13789-001
13789-002

Anyone know which KORRY it is?

James