Results 11 to 20 of 26
Thread: Landing and Taxi Lights
-
11-25-2007, 10:47 AM #11
-
11-25-2007, 11:19 AM #12
- Join Date
- Dec 2006
- Location
- Ireland
- Posts
- 255
In FS9 if you remove the panel.cfg or its folder, FS uses a panel.cfg from the closest A/C then.
You should use in any case a Panel folder with a panel.cfg, e.g. we use ever a panel.cfg where are only the views defined, nothing else.
[VIEWS]
VIEW_FORWARD_ZOOM= 0.70
VIEW_FORWARD_DIR= -7.5, 0, 0
VIEW_FORWARD_RIGHT_ZOOM=0.70
VIEW_FORWARD_RIGHT_DIR= -8.0, 0, 50
VIEW_RIGHT_ZOOM= 0.70
VIEW_RIGHT_DIR= -8.0, 0, 90
VIEW_REAR_RIGHT_ZOOM= 0.70
VIEW_REAR_LEFT_ZOOM= 0.70
VIEW_LEFT_ZOOM= 0.70
VIEW_LEFT_DIR= -8.0, 0, 270
VIEW_FORWARD_LEFT_ZOOM= 0.70
VIEW_FORWARD_LEFT_DIR= -8.0, 0, 310Regards
Thomas
-
11-25-2007, 11:28 AM #13
Perfect, Thanks I will try this right now.
Thanks Thomas.
Trev________________________
Trevor Hale
-
11-25-2007, 11:55 AM #14
Ok, Well that didn't cure the issue. Made no difference at all.
Only the Taxi and Landing lights do it. Is it possible this is a battery drain issue?
Where Pmsystems is telling the lights there isn't enough batter juice to light them? I have confirmed that when PMSYSTEMS is shut down, my lights stay on.
Any ideas Thomas?
Trev________________________
Trevor Hale
-
11-25-2007, 11:59 AM #15
- Join Date
- Dec 2006
- Location
- Ireland
- Posts
- 255
What logic do you use for the lights?
Regards
Thomas
-
11-25-2007, 12:00 PM #16
I am using Build 109 737 default logic. Modified for 3 engines.
fsLogoLight = LogoLight
fsBeacon = Beacon
fsLandLight = LandLightR or LandLightL
fsLogoLight = LogoLight
fsTaxiLight = TaxiLight
fsWingLight = WingLight
fsNavLight = WingLight
fsStrobe = Strobe <> 1________________________
Trevor Hale
-
11-25-2007, 12:11 PM #17
- Join Date
- Dec 2006
- Location
- Ireland
- Posts
- 255
Should not be the problem.
Just show with FSUIPC these values via "Logging" and check "AdvDisplay".
D0C as U8
2834 as FLT64
What values do you see when the Lights
- are switched ON
- when they go OFF by itselfRegards
Thomas
-
11-25-2007, 12:13 PM #18
K.
It might take me a bit to figure that out, SO I will post back here with my findings.
LOL Just frustrating because as you said, Logic should be fine, but as long as pmsystems is off they work.
Thanks for your help So far Thomas.
Trev________________________
Trevor Hale
-
11-25-2007, 12:18 PM #19
- Join Date
- Dec 2006
- Location
- Ireland
- Posts
- 255
iIn the Aircraft.cfg (FS) there is under electric the setting when the differend systems are switching to OFF because of low power. May be in your logic the GEN's switches not correct to ON and the Battery in FS will be discharched.
Regards
Thomas
-
11-25-2007, 01:38 PM #20
I checked the aircraft.cfg and everything appears to be ok.
What I suspected was that my stupid interface (which is crap) was changing the fslandlight and fstaxilight different then Pmsystems changes it.
so by commenting out the pmsystems variables
//fsLogoLight = LogoLight
//fsBeacon = Beacon
//fsLandLight = LandLightR or LandLightL
//fsLogoLight = LogoLight
//fsTaxiLight = TaxiLight
//fsWingLight = WingLight
//fsNavLight = WingLight
Everything works swimmingly. now.
Anyone want to sell their old interfaces, let me know. This one is going out the window so I can drive over it a few hundred times.
Thanks for all your help
Trev________________________
Trevor Hale
Similar Threads
-
Nav lights Taxi lights
By mocha22 in forum General Aviation (GA) Builder DisccusionReplies: 2Last Post: 03-04-2011, 09:35 AM -
Taxi Lights
By hurl2space in forum General Builder Questions All Aircraft TypesReplies: 19Last Post: 02-23-2010, 03:10 AM -
Airbus A319 IFDG Taxi lights Switching?
By brianwilliamson in forum PMSystemsReplies: 1Last Post: 07-23-2009, 11:06 AM -
Landing lights
By Jackpilot in forum General Builder Questions All Aircraft TypesReplies: 1Last Post: 03-13-2008, 06:11 PM -
Landing lights
By aviaparts in forum General Builder Questions All Aircraft TypesReplies: 7Last Post: 03-17-2007, 04:14 PM
Girls in your town
A320 Sound Files Missing