A320 FMGS B52

[Barrykensett]

I have slightly different spoiler arm problem. On sim startup the spoiler arm message is displayed when switch is on or off but spoilers remain retracted. After take off resetting spoiler arm to off does not kill message. On landing the spoilers deploy as normal but will not retract when selected, nothing will retract spoilers until sim is shut down. Until realising what is happening I have been stuck on runway after auto land as auto brake does not release when spoiler arm is cancelled; I can kick the brakes to release.
Everthing worked fine until the latest update. Keyboard / does nothing for me in P3D.
Barry
a320sim.com

[Mouseviator]

Hello,


I have B52 on simulator with Skalarki A320 cockpit and some interresting issues with this latest build.
If I land the aircraft and then reposition it back in the air (by FS Flight Control), the HDG/NAV autopilot
function does not work. The change in heading is diaplyed on ND and there is also indication on FMA, even flight
director moves as it should, but the aircraft does not.
Also, if reposition after landing for takeoff and set autobrake to MAX, the brakes get stuck and the aircraft will
not move unless the autobrake is disarmed. These all happens after repositioning aircraft after first flight.
If I restart the server programs, it all works ok again. Looks like some variables are incorrectly synchronized or
something. Did not happen on previous build I had - B50. Did anyone xperience something similar or any ideas what
would cause this?

Thanks and have a nice flight

[asessa]

Hi JL, i've this problem in ND with "plan" mode selected



In "arc" mode , the fp was showed right



Any idea?

[asessa]

Up! Can anyone check if have the same problem?

I'm running JH now and i have this problem

[Leonidas]

Up! Can anyone check if have the same problem?
I'm running JH now and i have this problem

This happens always or just at the specific runway? I'm asking because mine is OK, but I don't try this airport.
Regards

[asessa]

This happens always or just at the specific runway? I'm asking because mine is OK, but I don't try this airport.
Regards

With b52 always... But I had only 3 flights and all was in Canada.. I'll check in Europe.

Tnx

[bbruechmann]

JL already said that the top of descent arrow is not shown on the ND in this Version. And he promised it will be back on ND in the next update of FMGS.

[jeehell]

Hi,

I put a new version online through the updater or from here:
http://www.jeehell.org/A320FMGS_B52.2.18.exe

!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
- A navdata re-build is necessary !!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
-New EGPWS system: EGPWS option must be installed only on ONE computer, EGPWS data should be put on that computer in folder c:\A320FMGS\EGPWS\EGPWS data (if you used the default installation path..) Then you should share c:\A320FMGS\EGPWS\EGPWS folder for all computers where an ND runs (not needed if EGPWS is installed on a computer running both NDs). The paths described here can be changed during isntallation, though default configuration is encouraged.
-Enhanced FBW flare law
-Enhanced FBW C* law
-Fixed SIOC Creator issues for MCDUs declaration
-Fixed V1 callouts not playing
-ND has been stripped of most logic to gain some more performance (RAM use will decrease a lot, CPU should decrease a bit)
-UDP mode for ND route display is now default. NDs VOR/NDB/ARPT/WPT display requires this UDP mode to work.
-Fixed some route not drawing after a certain amount of points on the ND.
-Fixed T/D not displayed
-Fixed intercom crashes
-Fixed trim not returning to 0° on ground
-Fixed some FMA modes and ATHR speed/THR modes.
-Added native Symulatory support

cheers
JL

[iwik]

Thanks JL very much appreciated.
Regards
Les

[Leonidas]

What is UDP mode for ND?