Results 1 to 2 of 2
  1. 07-16-2016, 08:43 AM #1
    No Longer Active
    No Longer Active is offline
    1000+ Poster - Fantastic Contributor
    Join Date
    Nov 2008
    Location
    Europe
    Posts
    1,931
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    JeeHell Flaps & Spoilers Question

    This may sound like a dumb question, but I intend to make my flaps and spoilers using pots instead of rotary switches etc. I can pretty much connect a pot to an input card easily and then just tell JH Config the 5 positions, is this the way to go. This is definitely the easiest way for me, I am assuming this IS the way to do it right?

    Kind Regards.

    Alex
    GA or the Highway!
    Reply With Quote Reply With Quote
  2. 07-16-2016, 12:06 PM #2
    brianwilliamson
    brianwilliamson is offline
    300+ Forum Addict
    Builder Of The Month / Point Value: 100 Builder Of The Month / Point Value: 100
    Total Awards: 2
    Total Points: 200



    brianwilliamson's Avatar
    Join Date
    Oct 2005
    Location
    Gold Coast-AUSTRALIA
    Posts
    455
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: JeeHell Flaps & Spoilers Question

    Alex, absolutely the correct way to go.

    Cheers..................Brian W
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »