A320 FMGS B42/43

[asessa]

strange antonio...
...no autoland blinking in my setup...sounds like a local problem
fil

Maybe , the problem occours only with CockpitSonic FCU ..

[OmniAtlas]

Hi , i'm using B43 and i have the AutoLand korry switch is always blinking (cpt side)... why ?

Have you wired up both the captain and FO autoland side?

I noticed with my setup, when only the FO side was wired up, it would blink on FMGS startup.

After I wired up the captain autoland side all was good.

[asessa]

Hi Ben, i've a single seat (cpt) home cockpit and i didn't have this problem with B42 .
For me it isn't a big problem anyway

[jeddmc]

i've try insterting flightplan using navigraph updated database
but why plane speed and altitude not follow that flpn ?

[stefangr]

Hi,

is it OK that after pressing speed, heading and altitude knob on FCU, the heading number remains there? I would expect to see 3 dashes as it does for speed and V/S:



I have entered a complete route without discontinuities and filled out all necessary pages on MCDU.

Thanks
Stefan

[jeehell]

Depends on where and when you pushed the HDG selector. Pressing means arming, it engages only if in the right circumstance, and it then goes to dashes.

JL

[jeddmc]

anyone seen ils blinking on FD while approach ?

[Leonidas]

Hi,
is it OK that after pressing speed, heading and altitude knob on FCU, the heading number remains there? I would expect to see 3 dashes as it does for speed and V/S:
I have entered a complete route without discontinuities and filled out all necessary pages on MCDU.
Thanks
Stefan

Hi
This happens to me too after 42.1 or 43 update. I think during "before start checklist", it should be dashed.

[OmniAtlas]

anyone seen ils blinking on FD while approach ?

Turn on the LS button

[stefangr]

This happens to me too after 42.1 or 43 update. I think during "before start checklist", it should be dashed.

I just checked again. The dashes come up during T/O roll when thrust levers are moved into FLEX or TO/GA. I did not notice these dashes coming up then, and - as you said - it must have changed recently.

Thanks
Stefan