Results 1 to 5 of 5
-
05-05-2015, 04:30 AM #1
- Join Date
- Aug 2014
- Location
- Bangkok
- Posts
- 4
Cannot read value from JeeHell by fsuipc offset
Hello everyone.
This my first post.I have question about how to read value from JeeHell this difference from PMDG? Usually I use Link2fs for read offset to check value but I cannot read any value from offset JeeHell.What I do wrong? Need to config? Please advise to me.
Thank you.
-
05-05-2015, 05:45 AM #2
- Join Date
- Aug 2014
- Location
- Bangkok
- Posts
- 4
Re: Cannot read value from JeeHell by fsuipc offset
5-5-2558 16-41-40.jpg
I try to open FSUIPC Connect this show "Not compatible with FSX/P3D......"
-
05-05-2015, 07:48 AM #3
Re: Cannot read value from JeeHell by fsuipc offset
Did you run configure.exe (tick This computer is running FS9/X), and then StarterFSX.exe?
Soarbywire - Airbus Flight Simulation and Engineering | Jeehell FMGS - Free professional A320 avionics software for the cockpit enthusiast.
-
05-05-2015, 10:39 PM #4
- Join Date
- Aug 2014
- Location
- Bangkok
- Posts
- 4
Re: Cannot read value from JeeHell by fsuipc offset
This my step after open computer
1.Open MSFX and select JH A320.
2.Go to C:\A320FMGS and open configure.exe and select This computer is running FS9/X.
3.StarterFSX.exe
4.Go to C:\A320FMGS\FMGS Server and open FSUIPCconnect.exe but same result.
Is this correct step.
Thank you JeeHell for your support.
-
05-06-2015, 01:13 PM #5
- Join Date
- Mar 2008
- Location
- France,Nice
- Posts
- 2,652
Re: Cannot read value from JeeHell by fsuipc offset
FSUIPCconnect is not used to have FSUIPC hardware controls. You must not use that with FSX/P3D
You just have to install FSUIPC supprot during installation. Then, starterFSX will launch hardwareConnect which adds the FSUIPC support.
regards,
JL
Enter and win!
JeeHell FMGS on a remote Computer