A320 FMGS B31

[Miatanet]

Hi Stefan
did a clean intall from the link above, and it works .

Cheers
Stefan

[RigoA320]

Hi Stefan


I have the same problem with stuttering when climbing have, found when you get the millibar 1013 adjusted the problem


lg Rigo

[RigoA320]

Ergänzung
# Wenn nicht 1013 Millibar eingestellt ist das Problem

[startrail]

Hi JeeHell;


I have extracted the EGPWS , when I press TERR button I get two small windows with zeros and no more graphics.


Thanks

Mike

[jeehell]

Hello,

Not sure what you did exactly, but to sum up: you need to get the data from USGS, unzip it, extract the nexessary data using "egpws data extractor", and make sure the files are in the correct folder (EIS\EGPWS data\XX with XX going from 00 to 82, total 27 folders with 251 files inside each of them).
Also, the TER display is not always instantaneous, the ND must load the data which can take up to a couple minutes after ND start.

JL

[Miatanet]

Hi all
just had a fantastic flight from LSZH to EDDF without any trouble. No problems at all. It was wunderfull . All went good even with REX weather engine and TomCat running.

Great work JL !!!
Best
Stefan

[startrail]

Hello,

Not sure what you did exactly, but to sum up: you need to get the data from USGS, unzip it, extract the nexessary data using "egpws data extractor", and make sure the files are in the correct folder (EIS\EGPWS data\XX with XX going from 00 to 82, total 27 folders with 251 files inside each of them).
Also, the TER display is not always instantaneous, the ND must load the data which can take up to a couple minutes after ND start.

JL

Hello JL

I have extracted the HDR that Using EPGWS in and the files are in the path you have mentioned . Have waited over 15 minutes but nothing . Could it be using divide by 1 is the problem even though that I have used it in the past and worked perfectly.

[tote_320]

Hi all
just had a fantastic flight from LSZH to EDDF without any trouble. No problems at all. It was wunderfull . All went good even with REX weather engine and TomCat running.

Great work JL !!!
Best
Stefan

Me too! This time with weather from Open Clouds, with lots of wind changes and it was perfect!

thanks JL

[RigoA320]

Hello JH.

Yesterday I made ​​an update, and carried out a test flight

Very nice, everything works well, the Gear Lever of Cockpitsonic now works very well, as it should be. Thank you.

Regards Rigo

[jeehell]

Hello JL

I have extracted the HDR that Using EPGWS in and the files are in the path you have mentioned . Have waited over 15 minutes but nothing . Could it be using divide by 1 is the problem even though that I have used it in the past and worked perfectly.

No, this should not be the problem. I can only think of a few things right now:
1) you did not get the files for the region where you're flying
2) The files have to be in the EIS folder on the comptuer where you run the ND of course. If you have separate comptuers f or CPT/FO, you need to have the data o both computers.
3) you are neither in ARC or NAV mode (EGPWS is hidden in ILS/VOR/PLAN)
4) you TER button is not working properly (you can try by going in the MCDU MENU then toggling EGPWS from there).
5) You have a problem with opengl drivers

JL