A320 FMGS Compatible with Cockpitsonic FCU/EFIS/AUTOBRAKES/ RADIO.......

[asessa]

Mathias of Cockpitsonic, tell me to check at Uwe Schneider GmbH | EHID

I sent an email to uweschneider to request information about license of A320 EHID.

Regards
Antonio

[asessa]

Hi, uweschneider give a free license for the drivers. So i can test ECAM....JL , where do i put your dll ?

[jeehell]

Hi

you need to put it in hardware modules folder. I suggest you install the EHID drivers on main FS computer. If you don't have the hardware modules folder,reinstall FMGS software and check FSUIPC support option.

Regards,
JL

[asessa]

Hi JL, I have done just as well, thanks

At the beginning of my tests, the panel works well, each button changes to a page on the SD, but the two "DUS" are not recognized by the software.


After I turned everything on overhead, I start to have "exception in EHIDModule.dll" whenever my action on the panel changes the page on SD.
Example: When I turn the APU should display the page on the SD but I get this error and the panel stops working (when I press the buttons nothing happens).


Any idea?


Regards
Antonio

[jeehell]

Hi

Ok I will look at that.
THe DUs dimmers are not yet implemented, it was only a test to see if I could use the EHID drivers...

Regards,
JL

[asessa]

Good, i'm sure your software will works fine also with EHID

Have a good job guy!

Regards

[asessa]

Hi JL, yesterday i done a complete (little) flight from Naples to Rome FCO and i didn't have problems with ECAM Panel.
Maybe the first time, i done many tests and the drivers gone in error.


So give me other time to test it , but if you want also implement Dus dimmers i will happy

Regards
Antonio

[jeehell]

Hi

I worked a little bit on the driver. I added the DUs dimmer pots.
Also, for those with a FCU, I started adding it, but only the inputs work (no LEDs or 7segments displays yet).
http://www.jeehell.org/EHIDmodule.dll

Regards,
JL

[asessa]

Great!

I will try it this evening!

[asessa]

Hi JL, i've just installed the new module but nothing is changed even if i can see log in the Hardware monitor
EHID:OBJ ID: 0x30205201
EHID:OBJ Value: 0x3800
EHID:OBJ ID: 0x30205201
EHID:OBJ Value: 0x3100
EHID:OBJ ID: 0x30205201
EHID:OBJ Value: 0x2E00
I tried to setup into Configuration, in the Dus relative section but i can't.
All pages are switched correctly.
Finally : can you manage also backlight?