Results 1 to 3 of 3
  1. 05-29-2011, 04:31 PM #1
    davemuir
    davemuir is offline
    150+ Forum Groupie
    Join Date
    Dec 2010
    Location
    CUPAR FIFE SCOTLAND NEAR ST ANDREWS
    Posts
    180
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    save money on connectors

    hi everyone
    when it comes to purchasing connectors for the leo bodnar interface
    card ,you can save money by purchasing radio control servo leads
    from any model shop or ebay they have the same pitch for the pins.
    cheers dave
    Reply With Quote Reply With Quote
  2. 05-30-2011, 04:53 AM #2
    ian@737ng.co.uk
    ian@737ng.co.uk is offline
    500+ This must be a daytime job
    Builder Of The Month / Point Value: 100
    Total Awards: 1
    Total Points: 100
    ian@737ng.co.uk's Avatar
    Join Date
    Jan 2006
    Location
    Oswestry, Shropshire
    Posts
    604
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: save money on connectors

    Quote Originally Posted by davemuir View Post
    hi everyone
    when it comes to purchasing connectors for the leo bodnar interface
    card ,you can save money by purchasing radio control servo leads
    from any model shop or ebay they have the same pitch for the pins.
    cheers dave
    or if you're good with a soldering iron, you can get these from Rapid in the UK.
    http://www.rapidonline.com/Cables-Co...-sockets/76075
    rgds

    ian
    Mr. Ian. P. Sissons is hereby recognised as an Honorary Flight Sim Captain following his passing in February 2016. This is in recognition for his commitment to Flight Simulation.

    www.mycockpit.org Featured Builder August 2008 www.737ng.co.uk
    FS9/PROSIM737/CPFLIGHT/Lots of BU0836X's and a Beer Fridge
    Reply With Quote Reply With Quote
  3. 05-30-2011, 05:12 AM #3
    Sean Nixon
    Sean Nixon is offline
    500+ This must be a daytime job Sean Nixon's Avatar
    Join Date
    Jun 2008
    Location
    EGNT
    Posts
    678
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: save money on connectors

    I use 2 way connectors with the standard 0.1" (2.54mm) pitch on my LED's as I hate soldering so much. Has the benefit of making them 'plug n play'.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »