Outputs doesn't seem to be right - opencockpits iocards

[archen]

Hi everybody!

I have just started on building my first cockpit. I'm going to use opencockpits IOcards and instruments (will build everything to save money) and simworld's MIP.

I've just started to play around with SIOC and OC mastercard and usbexpansion card.

I manage to make the landning gear annunciator to work and a 3way switch to work as landing gear level. The only thing I'm wondering about now is the outputs doesn't seem to be right?

I have connected the mastercard to an USBexpansioncard and from the mastercard I use OC's outputcards via 40pins flatcable.
Every output is numbered on the outputcard so I took all gnd cables to the ground output and the rest + cables to one output each.. all in a row.

When I connect it to the computer and ran contrlabor to try it out outputs is not right at all.. I connected the leds to outputs 11-16 and when I try to illuminate them throu controlabor the outputs is like 11,13,14,18,19,24.. Im not sure it was exactly those numbers but you get the point.. Should it be like is or am I doing anything wrong?

Thanks in advance,
Anders

[mpl330]

Hi Anders,

Check this page to see if it matches what you are experiencing:

http://personales.ya.com/micabina737.../hard/numi.htm

Cheers
Mike

[kiek]

am I doing anything wrong?

Yes, you are doing something wrong indeed: you have not studied the documentation
Note there is a difference between physical numbering and logical numbering. See the thread posted already by mpl330.

regards,
Nico

[archen]

Hi!

I switched the output and inputcard (cant see any difference between them???) and used a multimeter to find out which pin was GND and I found out that the input and output cards ain't the same.. I used the inputcard by misstake and thats why the outputnumbers wasn't right. After I switched cards everything seems to be OK!

One more questition thouh.. To connect the mastercard to the usbextensioncard I have now just connected the two db25 connectors togather (not using an parallell cable).. It seems to work with output.. Can I do like that or do I really need an parallellcable to connect them to each other?

Thanks for helping me guys! Appriciate any help I can get.

Like this:


/Anders

[kiek]

Hi,

The difference is described in the documentation ...

Here the info at my site about the bi-sexual break out boxes: http://www.lekseecon.nl/iocards.html#breakout

yes, you can connect them directly (without a cable)

regards,
Nico

[archen]

That makes sense! Thanks for the link!

regards,
Anders