Results 1 to 3 of 3
-
07-25-2010, 05:26 PM #1
different ways to stop pulley slipping
hi guys,
was just researching the different ways people have gone about stopping the line slipping on pulleys in their setup, we are just completing our yoke setup (dual control)....i was thinking of fishing weights crimped on the line above the pulley but does anyone else have any suggestions
thanks in advance
James[B][I]"Life is just a ride" - Bill Hicks Esq.
-
07-25-2010, 08:13 PM #2
Re: different ways to stop pulley slipping
G'day James,
This is how I lock wires to pulleys using the brass ring and screw from a 'blue point' electrical connector. I used 2mm stainless steel wire rope to link my dual yokes and I put the same clamps on the yoke heads that I sell!
Cheers Gwyn
www.aerosimsolutions.com.au
737NG using Prosim737, Immersive Calibration Pro, Aerosim Solutions motorized TQ & cockpit hardware, CP Flight MCP & FDS SYS1X, SYS2X & SYS4X, FDS PRO FMCs, AFDS units & Glarewings, Matrix Orbital ELEC display, Pokeys Landing & Cruise alt display, Buttkicker Gamers, 3 x BenqMW811ST projectors with a Matrox Th2Go
http://www.aerosimsolutions.com.au
Supporter of MyCockpit.org, please join me in donating!!!
-
07-26-2010, 04:12 PM #3
Re: different ways to stop pulley slipping
Cheers gwyn,
this is great......much better than the fishing weights....got some today job done..
thanks again
james[B][I]"Life is just a ride" - Bill Hicks Esq.
Similar Threads
-
Just wanted to stop by and say hi
By Michael_B767_ATP in forum Welcome to MyCockpit New here? Introduce Yourself!Replies: 3Last Post: 02-16-2010, 10:06 AM -
Realism? No ways!
By AndyT in forum Pilots Lounge - Let your Hair downReplies: 7Last Post: 11-21-2008, 04:52 AM -
Pulley system
By Radar in forum My Cockpit UpdateReplies: 28Last Post: 09-25-2007, 07:01 PM -
Using Photoblogs and Galleries: Creative Ways to Share Your Photos with Windows XP
By MS Expert Zone RSS Feed in forum Computer Hardware SetupReplies: 0Last Post: 12-28-2006, 11:30 AM -
Flaps do not stop at 5.
By Matthew Schoenberg in forum PM General Q & AReplies: 17Last Post: 04-14-2006, 02:40 PM