Results 1 to 3 of 3
  1. 03-11-2017, 03:14 PM #1
    imported_Suggy
    imported_Suggy is offline
    25+ Posting Member
    Join Date
    Dec 2004
    Posts
    71
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    EFIS ARPT, NDB, WPT and VOR.D not showing on ND

    Hello everyone.

    Since upgrading the nav data (Navigraph) I cannot get ARPT, NDB, VOR.D and WPT to show on the ND but yet CSTR does show when selected.

    The MCDU confirms it is using the new nav data.

    I have followed the the procedure to install the nav data as discussed in this forum and have the bin files in the FMGS nav data folder. I've deleted them and 'rebuilt them' but to no avail.

    Im stuck what to do next....

    Any suggestions would be most welcome.

    Kind regards,
    Darren Sugden
    Reply With Quote Reply With Quote
  2. 03-11-2017, 10:45 PM #2
    OmniAtlas
    OmniAtlas is offline
    2000+ Poster - Never Leaves the Sim


    OmniAtlas's Avatar
    Join Date
    Jun 2012
    Location
    Sydney, Australia
    Posts
    2,107
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: EFIS ARPT, NDB, WPT and VOR.D not showing on ND

    The bin files need to copied to all client and server computers. Are you running with multiple computers over a network, or just one FMGS computer?
    Soarbywire - Airbus Flight Simulation and Engineering | Jeehell FMGS - Free professional A320 avionics software for the cockpit enthusiast.

    Reply With Quote Reply With Quote
  3. 03-13-2017, 04:41 AM #3
    imported_Suggy
    imported_Suggy is offline
    25+ Posting Member
    Join Date
    Dec 2004
    Posts
    71
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: EFIS ARPT, NDB, WPT and VOR.D not showing on ND

    Many thanks.

    Copying the bin files to the navdata folder on the networked computer running the PFD and ND displays did the trick!

    I had assumed all the networked computers read the the bin files residing on the server computer - my two computers which run only the MCDUs have no navdata folders. The key is then to ensure the bin files are in the navdata folder which are created in the PFD/ND installation.

    Once again, many thanks.

    Regards,
    Darren Sugden
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »