Results 1 to 2 of 2

Thread: Gauge Question

  1. 04-08-2014, 01:55 PM #1
    jketelings
    jketelings is offline
    New Member
    Join Date
    Apr 2014
    Location
    The Netherlands
    Posts
    1
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Gauge Question

    Hello,

    Today I took one of the fuel flow gauges out of the cockpit from our dead beech 200 sim at school to see how it worked. It had two connections and if I applied approximately 45mV on it, the gauge indicated zero. If I applied approx 0.8V on it, the gauge indicated maximum.

    So I wonder, how I am going to make i.e FSX drive this gauge?

    Regards,
    Jeffrey
    Reply With Quote Reply With Quote
  2. 04-09-2014, 08:24 AM #2
    davemuir
    davemuir is offline
    150+ Forum Groupie
    Join Date
    Dec 2010
    Location
    CUPAR FIFE SCOTLAND NEAR ST ANDREWS
    Posts
    180
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Gauge Question

    Hi jeffry
    check out claus Hanson on you tube
    he shows the micro maestro card that you can
    make any gauge
    cheers
    dave
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »