Results 1 to 2 of 2
  1. 08-28-2008, 09:19 AM #1
    super80
    super80 is offline
    25+ Posting Member super80's Avatar
    Join Date
    Nov 2007
    Location
    Georgia, USA
    Posts
    49
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    737 coupler dimensions

    After little success in trying to source the couplings/bearings that fit between the control columns and crossover linkage, I am exploring having these parts created. What I would like to know is the length of this part. If someone who has these in their setup could kindly measure the coupling, I would be greatful.

    see attached photo**********

    Thanks,
    Vic
    Attached Images Attached Images
    Reply With Quote Reply With Quote
  2. 08-28-2008, 01:29 PM #2
    super80
    super80 is offline
    25+ Posting Member super80's Avatar
    Join Date
    Nov 2007
    Location
    Georgia, USA
    Posts
    49
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    FYI, Hans Schuetz emailed me this information. The width of the couplings are 4,5 cm (which should be 1,7
    inch)


    Thanks again Hans!
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Help with CRJ dimensions
    By BlackWidow in forum Where to Start Building a Home Cockpit
    Replies: 10
    Last Post: 02-20-2016, 05:55 AM
  2. 727 Mip Dimensions
    By ozziesim in forum General Builder Questions All Aircraft Types
    Replies: 4
    Last Post: 12-10-2008, 06:27 AM
  3. Dimensions
    By Mac in forum Cockpit Outside Visualization
    Replies: 6
    Last Post: 09-12-2008, 01:53 AM
  4. 744 TQ dimensions
    By Bobgraag in forum Where to Start Building a Home Cockpit
    Replies: 1
    Last Post: 04-05-2008, 09:02 AM
  5. In need of some dimensions 777
    By blind0wl in forum Welcome to MyCockpit New here? Introduce Yourself!
    Replies: 3
    Last Post: 01-02-2008, 10:10 AM