nricky's New GA Cockpit

[nricky]

Hi Everyone

Now it is time that I finally introduce my cockpit to everyone. I Have been working on my cockpit for a long time. Also starting to learn how to cnc mill work. Have not done a lot with it, will have to design a few panel and then let the mill make it for me. I have learned a lot over the years and I think it is time that I will help other in what I did.

With my sim I can fly every plane that I want. At the moment flying mostly with a Piper Seneca PA-34 T200. Most people are building a 737, that will cost me too much. The fun is still there in flying a small plane.

I also have a web page where you can see what I have done. At moment I am reworking my page, will be posting a lot of info in the future. www.flight.nrick.net

Here are a few pictures in building the mip http://www.flight.nrick.net/building%20cockpit.html

P1070694_Bildgröße ändern.jpg



There are more pictures on my website.

In the near future will post my sioc code on my site, which I use to run my sim with.

Cheers Norbert
www.flight.nrick.net

[No Longer Active]

Looking good, looks like you have put some good engineering into practice, also it could double up as a generic trainer, just load up the panels and go, well done pal!

Alex

[Joe Cygan]

Looks great Norbert! Keep up the great work.

Joe

[Matt Olieman]

Nice work!!!! Looks like lot's of fun.....

Matt Olieman

[nricky]

Thank you all for the kind words.

Will show more when I get a few more things done. But always see on my page to see what I am doing. www.flight.nrick.net

Cheers Norbert

[autocadplease]

Nice job, Norbert!