Results 1 to 2 of 2
Thread: e37 with OC master
-
08-27-2009, 09:15 AM #1
e37 with OC master
Hi everyone,
My apologies if this has already been discussed. In which case, I would greatly appreciate if someone could point me to that thread as I have done an exhaustive search but couldn't find anything on this topic.
Anyway my question is quite simple.. Does anyone know whether the E37 dual concentrics work with the OC master ? I was looking at the data sheet and comparing it to the cts 288 encoder although not dual concentric but the specs look alike. However rather than jumping the gun and ordering any from leo bodnars website.. I wanted to get some advice.
Happy simming
Shafian
-
09-28-2009, 07:48 AM #2
Re: e37 with OC master
Hello Shafian,
ELMA E37 produces two pulses per notch while CTS288 generates only one. Unfortunately I have not personally used OC hardware so I cannot give exact verdict but from some forum discussions that I have come across I understood that OC only works with CTS288 style input. I have seen that someone tried to get around this using OC software (I think it is SIOC) but it was not working properly as rotation speed increased. This is all I know so far...
Cheers
Leo
Similar Threads
-
Master Caution / Master Warning lights using FS2Phidget5 (noob)
By mhayling in forum Phidgets & Cockpit Simulator BuilderReplies: 3Last Post: 05-18-2010, 02:08 PM -
Oc master 64 outputs???
By shafian in forum I/O Interfacing Hardware and SoftwareReplies: 13Last Post: 11-12-2008, 08:47 AM -
Master BATT and Master Avionics confusion
By Tomlin in forum PM RJ GCReplies: 4Last Post: 08-25-2008, 09:03 AM -
LED:s to master card
By Jouni in forum I/O Interfacing Hardware and SoftwareReplies: 1Last Post: 12-10-2006, 09:29 PM
Pretty Womans in your city
Find Sexy Womans from your city...