I mounted the monitor behind the MIP this morning and have been playing around with Panel Studio for a couple of hours now.
The monitor is a tight fit under the Korry indicators, but I wedged it in. I took off the factory bracket for the base and used the screw holes to attach a couple of angle brackest that I opened up slightly to a greater angle to match the panel angle.
If this monitor would have been only a millimeter or small fraction of an inch taller it would have never fit. Talk about cuting it close.
You can see the obvious gap from the monitor bezel and I hope to take care of all of that with he instrument bezels when I get around to buildng them.
The ADI is smaller than it should be as is the altimeter, but compromises had to be made in order to use a monitor behind a real 727 MIP.
Now I just have to play with Panel Studio some more to get my pop-up windows and sound included. I haven't figured out how to do this yet.
http://i63.photobucket.com/albums/h1.../727panel5.jpg
http://i63.photobucket.com/albums/h1.../727panel4.jpg
http://i63.photobucket.com/albums/h1.../727panel3.jpg
http://i63.photobucket.com/albums/h1.../727panel2.jpg
http://i63.photobucket.com/albums/h1.../727panel1.jpg