interfacing real yoke trim switch with IO cards????
hi,guys,
things are progressing well ,but ive hit a snag,im trying to connect the yoke trim switch to a cyborg joystick,thats been set up with screw terminals,it seemed an easy way to connect the trim switchs and auto pilot disconnect as i can use fsuipc buttons menu,anyway i started getting funny things happening and on testing the four wires that come out of the switch i find that i should have one wire to joystick screw termnal and one to ground per trim direction to make the circuit,when ive tested the switch ive got one signal in and two coming out so each time i hit a trim up or down the joystick is getting two signals,
has anyone else used the real switches?also ive seen some replica switches somewhere but cant remember where they are,anyone any ideas?
as usual there is most likely an easy way to sort this out,but after spening most of the day on the flight deck it eludes me,(as usual???!!!!lol)
i would rather use the real deal as i hear they are very expensive,and dont want to junk it,
cheers lads,
steve
ive also found some korrys i would like to swap for some fds k series annuciators if anyone wants to discuss?
