Does anyone not see these problems?
Hi All,
I recently reported some airbus software issues to PM. They are very busy at present and therefore could not verify whether or not the issues I reported were faults or configuration problems.
Jonathan said they were not doing any airbus work at the moment and it was ok if I reported them here to see if anyone else was aware of them. However, I would like to ask the question in a different way; does anyone not have these problems? - if so, then I would really appreciate it if you could help me figure out what I am doing wrong!
This is what I see:
1. In SRS mode with a flex power take-off, the FD commands a pitch that allows the speed to exceed V2+10 knots.
2. At acceleration altitude, the thrust momentarily goes to idle and I loose too much speed before the thrust comes back to climb power.
3. When I engage AP, the aircraft severely pitches up suddenly and then goes a little crazy trying to recapture the correct pitch.
4. T/C, T/D points are never shown correctly and keep changing the whole time even though I am in a steady climb or steady cruise.
5. When in open climb or descent, the AP often captures an altitude that is somewhere between 100 and 200 feet before the correct altitude - I often have to Alt pull several times to get the climb or descent to get to the selected alt.
6. In approach mode with managed speed, as I deploy flaps, the speed will never reduce below F speed i.e. 180 knots so I have to go into selected speed mode to achieve the correct approach speed.
Thanks,
Ryan.