Spring loading for Flaps lever

I put this on another TQ thread, but think it can help as stand alone.

Here is one way to do it, all metal:
The rod B slides through the block A which is bolted on the lever.
B is lifted to disengage from the dented quadrant and the spring (compression) brings it back down on the next notch...easy cheap.


http://i24.photobucket.com/albums/c2...ingloading.jpg

thanks my flap lever presently isn't spring loaded i may consider fitting this when i next have my TQ out of the pedestal for overhaul.

Regards,geremy

Very nice indeed.... Thank you for sharing this and yes I think it did deserve a thread of it's own.

OMG!! What an awsome idea!! I was stuck on hoe I was going to achieve that sort of scenario!

Thanks again

Drewsta