Opencockpit cards strange problem
Hello,
First my setup. I am using 1 USB expansion card and two master cards. Each master card is tested and works OK connected to the USB by a DB25 M/F cable.
Today I tryied to test both master cards connected. I connected the 5V power to all cards and connected Master1 to J1 of USB and Master 2 at J2. Also changed the ini files so that The number of cards are 2.
Running controlador everything OK it recognises two cards. Tested the inputs on N1 master and everything OK, but when I test the inputs of master two they don't work as supposed. Closing Ground1 with Pin 1 at the controlador I am seeing all the inputs of this bank to be active pins (1-9) if I close ground2 with first pin of second bank I am getting the same so on.
If I change the masters and the No1 becomes No2 and vice versa I have the same problem. In few wolrds any card connected to J2 of the USB has the same problem. I have checked all connection at the usb just in case but haven't found anything.
Any suggestions???
Chris