Hi, I encountered a problem in offsets for n1 and n2 of B744 (MSFS 2004). I managed to get the offsets of EGT and EPR , and control them (increasing and decreasing) their values on EICAS. However, I cannot do the same thing on n1 and n2, using the same method.
These are the offsets that I managed to find for n1 and n2:
0898 for n1 and 0896 for n2.
This is the logics that I wrote:
if EngSwitch
Eng1n1 = counter 16384 100 //Eng1n1 = 0898
Eng1n2 = counter 16384 100 //Eng1n2 = 0896
else
Eng1n1 = counter 0 100
Eng1n2 = counter 0 100
endif
I used the same method for EGT and EPR and It works.
Can I clarify with you if the offsets that I used are correct and can anyone help me do correction to the logics above if I had written it wrongly?
Thank you very much for your help