I have bought both 10k and 100k pots to use for my yoke and elevator axis. They are both linear. I have wired them up to an old wheel and gears from the old wheel,and have had limited results using FS to configure the axis. I canget either to acuate only the left aileron or only the righ,( if i reverse the axis.)First are these the correct type of pots for this app. ?Second, am i missing the boat by not using FSUIPC for axis assignment, I read that with FSUIPC, one can define his own center point. Third, when I dissassembeled the control wheel, i saw only two wires leading to the pot, and only two were soldered in, yet there are three recept5acles. This is the case with my new pots as well they have three receptacles, do i use two or three wires? Which pot to use where? 10k, 100k, sliding, etc.