Gear instructions

Hello,
I'm looking for the instruction you have to put in FS2Phidget (equal to "G" keystroke). Which offset can I use to activate single switch ?
Many thanks for most appreciated help
Michel

Hi Michel,

the FS offset: for Gear up dec. 66079 = hex 1021F
for Gear down dec. 66080 = hex 10220

Hope this is what you are after

Best rgds

Peter

Thanks a lot then it looks that I will need to swiches in the gear box
Greetings
Michel

You could use one offset for when the switch is on and the other for when the switch is off. That would give you your 2 offsets as well.

Hi Bob, hmmmm can this be done with FS2Phidget ?
B. Rgds
Michel

Michel,

One offset (gear handle).

Two Values for Offset (gear up and gear down).

One switch with two Values (on and off).

Use Fs2Phidget (or any solution supporting Digital Input) to:
assign Gear up Offset value to a switch's Off position
assign Gear down Offset value to a switch's On position.

Gear Offset: 0BE8
Offset values: 0 = Up, 16383 = Down

Regards,
Alan.

Okidoki Alan, its is working.
Many thanks for your super support.
Ciao
Michel