listen to the ATIS

Hi,

with external hardware i dial in the ATIS frequency of the airport, but i do not get a spoken or written
ATIS out. what steps do i have to go through, to get an ATIS of the present airport in FSX ?

have you checked, it works without ext. HW?
Is the HW properly connected? Maybe check with an FSX internal software radio panel.

Hey Michael,

yes you are wright, i have to check it again.
do you know, if adding a software-panel (e.g. RMP1) to the allready installed jh-software will work fine ? i saw lately that i did not install this RMP1 from the beginning, because i had the skalarki hardware-panel.

you could add it to the list of components if you update JL.
It should be easier to test with loading an installed plane, like Cessna and see what it indicates on using your hardware panel

hi michael,
is it possible to check e.g. a skalarki RMP with an installed standard cessna plane in fsx ?

I tested my selfmade RMP like that. As long as standard FSUIPC offsets are addressed, it should work with Skalarki HW as well. At least this would be my guess.

my doubt started, when looking at the skalarki profiler, where you have to select the wright airplane, that profiler gets the hardware-component working. There is jeehell, prosim, md-80... but no standard cessna.
But i will give it a try, thanks michael

it´s working now after a lot of attempts,
thanks michael

Hi,

Can you please help me how to put ATIS system. I have A320 Fixed Base cockpit. Which hardware and software is require to listen ATIS ?

hi architfly, you need a kind of RMP (radio-management-hardware-panel or software based) to select radio-frequency and this should be connected to the flightsim you are using, so you can dial in a radio frequency to be listened to within e.g. FSX or Prepare3D. the easiest way is the software panel inside your flightsim.