Vishay 357 potentiometers wiring question

Hi allI have new Vishay 357 potentiometers and just need help re wiring them up. The wiring diagram is on the side it shows 2 is signal but nothing for 1-3, can someone tell me which is ground and which is earthCheers Rhys

Hi,
1 or 3 can be ground. Depends on which direction you turn the shaft as to the signal at 2 will increase or decrease. Usually cw the signal at 2 would increase. So when you wire it up if it goes the wrong way then reverse connections to 1 and 3.
If you are applying voltage to the pot make sure that supply voltage is not connected to the 2 pin.
Les

Cheers Les thats great thanks ,Can this be said for most Pots?. I picked up a $4 one from jaycar to do some testing but the download doc falls a bit short on info Cheers Rhys

Hi,
The same goes for any pot. The two ends are ground and signal in. Or ground and dc in if you are
using the pot connected as an axis, ie for a throttle or mixture control.
Just make sure you identify the wiper when using dc in, applying voltage to the wiper and turning the pot will cause smoke to appear.
Les
smoke to appear.

Thanks Les The pots will be used for x and y axis and pedals I m using Leo bodnar board Rhys