FMC Run-time error ´11´: Division by zero

Hi,

I have on a secondary PC (with XP SP3) PM installed. Everything is working fine. Well only the FMC I can run it with build 362 but not with 406. When I run it with 406 I get this error: Run-time error ´11´: Division by zero.

I de-installed the module and installed the demo. But same effect.

I hope anybody can help.

Thank you in advance

Hello,

I had the same problem, but I found out that (at least on my PC) the de-install did not completely remove all the files. Go to the directory where you installed your CDU software and remove all files by hand (after running the uninstaller ofcourse).

After reinstalling the CDU software everthing should run fine.

Good luck to you!

Thank you for your response. The problem I had was an old graphic driver. Well I never changes something till I have an issue.
But I was wondering why no CDU update was working anymore.... well after an update of the graphic driver evrything is working fine.

PS And installed and dinstalled the CDU and garphic driver sevral times till now everything is working ;-)