Question I am using momentary AML switches on my MCP and was wondering if its not possible to give this switch 2 commands so it can stay on in FS2004 when pushed and when pushed again turns off
Any help on this would be appreciatte it
regards,
Nihad
Printable View
Question I am using momentary AML switches on my MCP and was wondering if its not possible to give this switch 2 commands so it can stay on in FS2004 when pushed and when pushed again turns off
Any help on this would be appreciatte it
regards,
Nihad
Depends on what software you are using. I e.g. use PM and the following code works for me with momentary switches, such as the AML switch.
[FCU_SET_LOC]
offset=4F2
Length=4
FSType=Digital
OffValue=0
OnValue=28
Hope this answers your question.
Matt O.
Hi Matt,
I am trying to figure out all this so sorry about that.
With the code u just added in your reply do u use that in the fs2phidget? and yes I own the PM software too.
If not if u could please tell me where this code needs to be added.
regards,
Nihad