180 degree servo acts as 90 degress servo

Hello, has anyone expercienced this.

I have a 180 degree servo, but when I use FS2Phidget it uses it as a 90 degree servo.

In the Phidget control panel it sees it as a HITEC_HS322HD and operates it as 180 degrees.

Am I suppose to tell FS2Phidget it is a HITEC_HS322HD servo?
Is there an attribute in FS2Phidget that makes it act as a 180 degree servo? Maybe in the DIVIDE section? I have played with that and the most I can get id 90 degrees.

If the servo was just a 90 degree servo than why would the Phidget control panel software operate it as a 1800 degree servo....

I have converted a Bell 212 Fuel Gauge to servo, that what I working on.

Thanks, Gary
K E 6 J Z S Barstow

Gary,
Which version are you using? 4 or 5?
Regards,
Alan

Hello Alan, sorry for the commotion, I have been holding out moving to .21 from .19 and now that I have my servo is acting as expected. I have now migrated to 5.0.21 as of 2 hours ago, yippy!

Thanks for the get back.
Gary