Originally Posted by
bbruechmann
i went back on you first reply and have seen you use Skalarki. Go into the skalarki profiler and edit the profile you use. Delete the PFD/ND XFD switch from profile in case you donīt use the HW panel for it and see if that helps.Well, not knowing what exactly is your actual setup, i would start like:1. delete ALL axis assignments in P3D 2. check if there is maybe an axis or switch defined in FSUIPC and delete it. 3. change the EIS model 4. delete the PFD.ini and ND.ini in the subfolder EIS 5. in case if your monitor is connected via HDMI pull out the HDMI cable, wait 10 to 20 seconds and put it in again. 6. Delete all assignments in FMGS_config and re-assign only the ones you have HW for. 7. (will be announced if i have any further idea) 8. Ask JL desperatly for a hint
..