Am trying to select com2 TX but it will not work anyone else having trouble? Here is the ini code:
[COM2_TX]
Offset=3122
Length=1
FSType=Bitmap
Bit=6
Thanks for the help,
Dan Fontan
Printable View
Am trying to select com2 TX but it will not work anyone else having trouble? Here is the ini code:
[COM2_TX]
Offset=3122
Length=1
FSType=Bitmap
Bit=6
Thanks for the help,
Dan Fontan
Dan,
You have the INI settings are correct.
Did you remember to enable component ?
(Have to ask :) )
What version of FS are you using ?
Create dummy tab within FS2Phidget and observe what values are being sent by FS when you change COM2 TX on FS screen.
Alan.
Enabled= checked
FS version = 2004.1
open dumy window = doesnt change FS settings, but com1 and both do change the settings.
For some reason the 7th bit always has a one in it even though it is programmed for the 6th bit. I am seeing this on the input "fs value" of FS2phidget. Could this be causing it, and what is causing that bit to be a 1?
Thanks for the help,
Dan
Dan,
The entire byte is displayed.
FS and FSUIPC work with bytes.
Some settings manipulate bits within a byte
(This is the definition of bit mapping).
I felt is was more helpful to display entire byte.
That 7th bit is COM1 Transmit.
Alan.
Alan, Thanks for the quick responses and your dedication. Although I still can't get it to work and I noticed on the com1 byte its just all zeros, wouldn't it be the same as the com2 one since the same information is being passed through the same byte?
Can someone please attempt the code in the first post to see if it works or if its just a problem with fsuipc of just fs itself?
Thanks,
Dan
Alan I sent you a message if you would like to contact me directly to solve this issue my email is danfontan@cox.net or navalaircrewman@aol.com
Ok, I was playing around with it and found out if I hold the button down to select com2 while i click on set FS to hardware, the 1 in the 7th bit dissapears, I let go of the button and com2 selects.
Alan do you know what I'm doing wrong?
Thanks for the help,
Dan
Dan,
Have you been using a toggle or momentary switch up until now for COM2 ?
Alan.
momentary. I even reassigned one of my on/off (basically a toggle) and to no joy.
Alan, why would "com2 tx" read the 7th bit as a one and "com1 tx" doesn't read the 7th bit as a one or the 6th as a one when com2 is selected to tx?