Nearing completion now...

A test fit to the control stand.

The flap mechanism and the slider pot and linkage is installed. Now I have to fit and install the stab trim cutout/normal switches and then finish the flap mechanism housing.

I ordered the Beta Innovations Plasma MM2 to interface with. I was going to go with the FDS input modul, but the BI is much less expensive for the same capabilities.

http://i63.photobucket.com/albums/h1...rottlefit1.jpg

http://i63.photobucket.com/albums/h1...rottlefit2.jpg

Impressive, indeed :)

Thanks for the photos.

Thank you Matt. It's been a long time coming.

Just waiting on the electronics now. The card shipped today, so it won't be long now.

I still have a few placquards to mount.

http://img182.imageshack.us/img182/1367/boeing1uz8.jpg