Hello
I'm having FSBUS card I can use them in other software do you have?
Printable View
Hello
I'm having FSBUS card I can use them in other software do you have?
Simple answer:no
Regards
Jan
Thanks JAN
How could for PMGD NG
If you know the offsets for the PMDG NG you can declare them in the FSbus software and use the fsbus cards.
Google PMDG NG offsets or find out here on the forum
Good luck
Jan
Thank you very much Jan:)
Could you write an example for pmdg NG.
I'm using FS2004
can I use the joystick button key cards as FSBUS
https://www.facebook.com/rtszkrsn eklermisiniz
What version of FSbus software are you using?
Reed the documents who comes with the software installer.
You must change the default (FS2004) offsets with the PMDG offsets.
Goodluck
Jan
Thanx Jan
I'm using FSBUS 2.4
But I could not find on the inernet PMDG ng ofset.
Hi guy's could you please let me know where I can find all the info on the diff FSBUS cards. I would like to build my own cards but can't find any info on them or any PCB designs? I am new to this.
Thx
Sean
I have FSBUS Board PCB and schemma.I can send in your mail
Yes please my mail is: seanatp1@gmail.com please thanks for the help
Please check your e mail
I don't use the PMDG, so I couldn't help you with that
Jan
Thx man this is gr8t!! I will push on your button again once I need to start using them hehe. Thx man
Sean
You don't have any documentation on these cards parts list an so on? I'm also looking for the FSBus IO Card? If you don't have this could you steer me in the right direction maybe?Quote:
Originally Posted by seanatp
thx Sean
The version 2.4 is a old version. There is a new software version and pcb boards available at: http://www.rvdijk.nl
Take a look, it's a great site about the fsbus stuff.
Jan
go to www.fsbus.de for version 3.0.2
when you have install this then you look in the installed map
thereare the drawings
greets from gaitflight
www.gaitflight.nl
Thank you all for your help!!
Just another question the micro controllers do they get programmed after you build the boards by the FSBus program once you plug the boards into the PC or do you have to program them before installing them with a micro controller programer?
thx
Sean
Sean,
There is an onboard 6 pin ISP on the com. board to program all the different Atmel controllers. So first build the com board.
Regards
Jan