Hi all, Hi JL, does your soft compatible with P3D v2 ?
Printable View
Hi all, Hi JL, does your soft compatible with P3D v2 ?
Hi,
It has not been tested yet, though it should theoretically work...
JL
rgr , thanksQuote:
Originally Posted by jeehell
I am also thinking of purchasing the P3D v2, can you please share your experience (if you made some)?
Thank you!
Stephan
Hi Stephan, you can try p3d v2 buying a monthly license (9.99$) and test it.Quote:
Originally Posted by Stephan Schwarz
I will do in this way
Works without any major issues so far :)
Good News :)Quote:
Originally Posted by OmniAtlas
Hello all,
just my experience with P3D v2. With newest version of FSUIPC works perfectly with JL-FMGS. No crashes, just better performance and much better look on screen. :)
Regards Henrik
Hello all
I have some problems with P3d v2.
I can't use the Ext Power to start the Airplane. It only work, if the Bat Switch in the Airplane is set to ON and i load the Airbus.
Also i can't start Eng 1. Only with ctrl+e. Maybe i make somethin wrong, but in the FSX it works without problems.
You cannot use the default keys like "CTRL+E", you have to do the real procedures according the manual.
Regarding the EXT POWER I have no idea, maybe another P3D user can say someting.
I know, that i have to do the real procedures. Eng 2 starts normally, but Eng 1 come up to 20% N2, but N1 don't rise up. When i press ctrl+e rise N1 up an the Eng runs normally. In FSX its works normally with the same procedures.
Maybe i have some settings false?
hm, first I thought that it is mandatory to start ENG1 and then ENG2. My last flight shows that this is not the case.
You may also start ENG2 first.
Have you tried the following scenario:
- load the standard flight with the Cessna 172 at an airport of you choice
- shut down the engine and switch off all electronics
- you now have a cold and dark situation
- load your JL airbus
- save this flight so you can reload this status again
- try to get the airbus running
Did it help?
Regards
Stephan
Hi ToTom
Thanks for the file.
With this work the Eng 1 normally.
Make sure the APU is turned on. Did you switch on the bleed switch?Quote:
Originally Posted by Beret
Works fine for me in P3D
I forgot to write: on this flight I set the trim to -1.6DN...Quote:
Originally Posted by Beret
This setting is for default weight and about 6.5 tons of fuel.