A320 FMGS beta 26

Hi all,

Concerning SRS mode not engaging and THR RED/ALT, there is a workaround:
-prepare all your flight (INIT, FPLN, PERF, etc...)
-When all is done and you FPLN has been inserted (not TMPY anymore) and you're sure you will not change it again before takeoff, reselect the RWY and SID.
-this will create a TMPY again, which you need to insert as active without any other modification.
-you can now set the THR RED/ACC
-you can now take off, the SRS mode (and most importantly the TO Phase) will engage
-You can now do whatever you want with the FPLN if you need to do revisions...

Best regards,

JL

Hi JL,

I just noticed another issue. Once I used the dir-to option I am not able to modify the FPLN in any way afterwards. It always gives me "dir to in progress" even the selected dir-to waypoint has been past already. And the destination runway is not shown anymore as a white bar on the ND. It now looks like a normal waypoint.

Anyhow... Great piece of work, man!!! Thanks!

Cheers,
Rob

Ah yes I came across this one today as well, to avoid it, afeter inserting your DIT-TO, go back to DIR page then without entering anything, go again to your FPLN page.

Thanks for these tips. Will try them tonight.

Tommi

EDIT:
Ok, have tested and FPLN, DIR and THR RED works like you said.

But in final I get a lot of A.FLOOR... In earlier message you said:
- AFLOOR and APdisconnect: which FS model do you use? did you switch to ifdg model (included in b22.1, Air France livery) or still use the PA one (airbus livery)? You should use the ifdg one

Where could I find this IFDG model? I only have PA with house colors. I have installed it with installer but it seems to be this PA anyway?!?

Regards,
Tommi

Hi Tom,

the IFDG model should be in the directory "iFDG FSX". You can find it in the main directory where you have installed v23.1.

Regards,
Rob

Hi Rob,
Thanks, found it. The first approach with the IFDG and still missing the GS :(

Edit:
Manually added FLYOVER don't work. When added for a STAR waypoint, plane don't fly over it. It starts it' turn about 4-5 nm before this point and fly to the next point of STAR.
Also having problems with autobrake after landing - yes I did land :) All for now,

Tommi

Hi JL
i have to report a minor problem.
when i try to rotate mcdu (right click, rotate...) just the display rotate and not all the software interface.
thank you for all your amazing work.
CIAO!

Hi,

I'll check the OVFY function. As for the MCDU, it's not intended to be able to rotate the keyboard in fact. I believe nowadays most CG cards can rotate the displays themselves, if not windows...

regards,
JL

Hello Jeehell,

I would like to use your project direct in MFS , without window do you think that possible to put .XML or .gau instead of .exe, with openGl or other

Thank you Jeehell

Best regards,

Jules

Hello,

This has already been discussed, the answer is no. It's not my goal, and would take too much time to do so.

Regards,
JL