hi jl,
is it correct that in the AP/FBW module the dropbox of flight dynamics shows only PA320 to choose from?
regards
fil
Printable View
hi jl,
is it correct that in the AP/FBW module the dropbox of flight dynamics shows only PA320 to choose from?
regards
fil
HI
@Papelin: when does the shaking occur? I need more info on that. I do not recommend turning the FBW OFF.
@Filippo: this is normal, do not touch the settings in the AP/FBW, they should be good by default.
JL
thanks jl...just wanted to be sure to make tests in "normal" conditions.
BTW, my friend alitalia cpt (retired) now type rating examiner on md80...now getting a conversion course to a320 was here last week and we just cast a glance at your suite: he suddenly noticed the fuel flow indication (800 @ idle) was far too high...i told him that FS is wrongly coded about furl consumption ...a known FS bug. do u confirm this is due to fs bug...or u can tweak those values accordingly?
anyway when flying a short round robin with autoland he said your suite flies actually better than their FTD at alitalia training center :-)
cheers
filippo
I cannot do much right now about fuel consumption. I'm not into FDE creation, and do not master that aspect...
JL
Hello JL,
I have FSUIPC support installed of all PCs but only transponder works. have you any idea to use the other funktions ( Stby and Mode C).
Best Regards Micha
HI
I'll look at it if it can be done easily.
JL
Hi to all
I'd like to mention a few things. (I use FDS I/O card)
1. When I turn steering tiller, the rudder moves too, but as I know they shouldn't.
2. I can steer the ACFT, no matter if Antiskid/NWSteering switch is OFF or ON. Is this normal?
3. When Antiskid/NWSteering switch is ON, on SD says in red: "STEERING A/SKID", in flashing green: "AUTO BRK MAX" and I can't select from Auto Brake panel the MAX, but when this switch is OFF everything is OK. This or the opossite is normal?
Thanks
Hi Leonidas,
1 & 2: since in FSX there is no separate tiller axis, I never took the time to cheat in my software. I'll do that some day.
3: it should be working correctly though? Are you using hardware there?
JL