what do you mean by that:
Printable View
it's not that long...
Perhaps our German speaking FMGS users can help Krahe out?
Hi JL -- the parking brake in my setup (Prepar3D 2.5) is no longer functioning with the latest beta.
Prior to the latest release it was working fine -- I have the brake setup in the FDS InterfaceIT creator as a Separate Press/Release function.
Regards.
I can confirm this, parking brake does not work. E.G. Starting sim, parking brake is set. After releasing Parking brake and pressing any brake pedel, unable to set parking brake again. Parking Brake msg in ECAM Display comes on for less than 1 sec and goes off again.
Hello Jeehell,
I have a problem with parking brake indication after latest update ( I think B41.2).
On ecam lower display parking brake does not appear to be on although the parking brake lever is on.
I'm using skalarki hardware.
Best regards
Ben
sorry, the P3D support should be good again...
Weird it did not work at all though?
JL
Thanks so much jeehell,
now parking brake is working good as before in P3D 2.5
Best regards
Ben
Hi JL, Thanks for your update.
I have some questions (Mine on FSX):
1. I have assigned a button on joystick for Parkbrake, however it does not work with latest update. after a pushback, I could not engage FSX's parking brake again. (Tried assigned button and Ctrl+. without success). the aircraft was moving with thrust idle.
2. On ground, Ecam Flight control page can be shown, however when I select another page, I can not go back to Flight control page anymore. After airborne, I also can not check the ECAM Flight control page. (It worked fine with vB40).
3. Set autobrake (Low,Med,Hi) for landing, after touchdown I dont see the "Brake" Red message on bottom left of FSX's windows, it seems that FMGS's autobrake has no effect.
4. FMGS_Config crash sometimes and not able to open again. anyone has this problem?
Thanks alot
Vu