737 homemade MIP

So you printed it out and it comes out 3 cm too small and you suggest printing it at 101% just to make it to scale?

I wouldnt lose any sleep over 3 cm.

Quote:

---

Originally Posted by Efe Cem Elci

So you printed it out and it comes out 3 cm too small and you suggest printing it at 101% just to make it to scale?

---

Yes make it real as posible

i heave print out but the screen is 18 and 17 and 16cm:( if you can try? to get a 18cm 18cm height and the another thing? (sorry) in the screen, if you see on markuspilot

Quote:

---

Originally Posted by super2277

i heave print out but the screen is 18 and 17 and 16cm:( if you can try? to get a 18cm 18cm height and the another thing? (sorry) in the screen, if you see on markuspilot

---

i slowed it but what can i do next? i need serius help??? whear can i begin next ting with the MIP panel?
http://i851.photobucket.com/albums/a...DSC00076-1.jpg

http://i851.photobucket.com/albums/a...7/DSC00078.jpg

http://i851.photobucket.com/albums/a...7/DSC00085.jpg

http://i851.photobucket.com/albums/a...7/DSC00084.jpg

Hi,

That looks good, can you tell which file did you use and how did you get the print of the MIP.

Regards
Abhay

Quote:

---

Originally Posted by autocadplease

Super2277,

I created some pdf files for you. What I did was tiled the MIP, MCP, Overhead and the Pedestal into separate files using A4 size paper. All you will have to do is print them off at 100% scale on A4 paper and paste/tape them together. The pages have a .25 inch overlap and have marks to help line them up. Then after you do that, cut the outline out and trace it onto your wood for cutting. Hope this is what you are after.
Either PM or post me you email address.

Note to anyone else: If these are of interest to anyone else I can upload them. Just reply or PM me.

---

Hi Autocadplease,

I would like to have those files for my build, please check your PM for my mail id.

Thanks a lot for all your help and contribution.

Regards
Abhay

Sorry for the late respons the was a little stop in building but i will begin today :)

Quote:

---

Originally Posted by super2277

Sorry for the late respons the was a little stop in building but i will begin today :)

---

Hi Super 2277,

Can you please tell which file did you use and how did you get the print of the MIP.


Regards
Abhay

Quote:

---

Originally Posted by abhay9

Hi Super 2277,

Can you please tell which file did you use and how did you get the print of the MIP.


Regards
Abhay

---

The file is in this thread