Oops, I thought you were talkin' about the KI-525A bezel.
http://i1221.photobucket.com/albums/...pic/altdwg.jpg
Printable View
Oops, I thought you were talkin' about the KI-525A bezel.
http://i1221.photobucket.com/albums/...pic/altdwg.jpg
Perfect, so the outside diameter of the bezel ring will fit perfectly. Could I ask for one more measurement that I am not seeing in the drawing?
What is the inside diameter of the bezel ring?
Attachment 7276
2.78 is the ID
Looking outstanding Louie...again!
Reid
Ditto, "Outstanding" !
I am starting to experiment with Link2FS and an Arduino to drive the 7 segment displays. Last night I got it working the servo for my flap control and a stall warning horn, next comes the 7 segment displays.
Tom,
What are you using for the horn?
Reid
Finally!
Now it's time to design the pcb.
http://i1221.photobucket.com/albums/...hbaypic/kx.jpg
http://i1221.photobucket.com/albums/...hbaypic/k2.jpg
http://i1221.photobucket.com/albums/...hbaypic/k1.jpg
At the moment the horn is a piezo horn that I am driving with a pulse modulated output off the Arduino.
The gears worked well. The range is a bit short but it's enough to get the separation between flap settings. I did what I thought was a final install today but after looking at it I will be reworking the position indicator and adjusting the opening in my MIP to get a better detent for the third falp position.