A320 FMGS B31

Quote:

---

Originally Posted by jeehell

Hi Stefan,

Do you have an antivirus which may be causing the trouble?

JL

---

Hi JL
just MS essentials, nothing more.

Regards
Stefan

well maybe check it's not causing troubles with that dll .
I do not have such issues...

JL

Latest update -- I get errors with ELEC PUMP fault even before the APU starts up.

When I turn on ext power I have the following errors:

HYD B+Y SYS LO PR
G+B SYS LO PR

I tried turning on GEN 1 and GEN 2 ELEC but I get faults.

-

addit -- Haha...I had the simulator paused. Silly me.....silly me.

Hi JL
deactivated MS essentials and is causing the same problem. What I found out, it is just crashing when FSX is started, when FSX is not started FMGS is starting corect. When then starting FSX the error comes up again. The message also says to reinstall the programm....
so I will do and report :-)
Best regards
Stefan

Ok that is very strange.
By hte way, do you actually have hardware from CockpitSonic? Because EHIDmodule is meant only to interface with that hardware.
So if you don't need it, simply delete it...

Best regards,
JL

Quote:

---

Originally Posted by jeehell

Ok that is very strange.
By hte way, do you actually have hardware from CockpitSonic? Because EHIDmodule is meant only to interface with that hardware.
So if you don't need it, simply delete it...

Best regards,
JL

---

OK, good to know. Using Marcins IO :-). So I deactivated it in the starter.ini and it works now.
Thank you JL.
Regards
Stefan

just want to report about the hardwareconnect issue someone was experiencing when using Skalarki hardware: in my sim i have ALL and ONLY skalarki hardware...now after some 20 h or more on many test flights after all the hardware was connected i NEVER experienced hardware connect issues or crashes. were the guys experiencing it using only skalarki hardware or a mix of different manufacturers?
cheers
filippo

For some reason my TAT is 80 C - and I'm at 20,000 ft.

I'm using OPUS...this is a known weather injection problem with P3D 2.0? Autopilot went crazy and my aircraft shortly crashed.

However it is good to know the TAT affects the temperature probe directly on the aircraft and the computers on board could not calculate airspeed.

Quote:

---

Originally Posted by filippoporcari

just want to report about the hardwareconnect issue someone was experiencing when using Skalarki hardware: in my sim i have ALL and ONLY skalarki hardware...now after some 20 h or more on many test flights after all the hardware was connected i NEVER experienced hardware connect issues or crashes. were the guys experiencing it using only skalarki hardware or a mix of different manufacturers?
cheers
filippo

---

Hi Filippo
just using Skalarki HW.
I think there was a Problem with the .dll itself (0kb) :-)

Regards
Stefan