Question for allyou guys with Throttle Quadrants!!

Hi Roberto,

My reverser switch - http://www.mycockpit.org/photopost/s....php?photo=600

My switch presses F2 repeatedly when made, and then sends a single F1 to cancel reverse through simboards when the lever is released, this works good!

Gwyn

Thanks Trevor and Gwyn... Actually I might have to work something like Trevor Basically advance the levers just a bit to disengage the reversers... Thanks for the help and Ideas!

Regards,

Roberto

I'm using snap switches and FSUIPC for the reversers on my 727 throttle.

The reverser levers are connected to another lever shaft that is located inside of the throttle shafts. The reverser lever pivots the other shaft upward to release contact on the snap switch.

It was simply a matter of telling FSUIPC what I wanted the switch to do when pressed and released.

There was really no room left in my throttle housing to add three more pots for modulated reverse thrust on all three engines. On my throttle, it's all or nothing.

http://img64.imageshack.us/img64/790...rottle4da5.jpg

http://img171.imageshack.us/img171/3...nished4vt4.jpg

Love your throttles dude! Amazing work you have done there I´ll show my work soon... Still some testing to do!

Thanks.

Roberto

Looks like I'll have to do some more reading!

A while back I posted a question on the FSUIPC forum, asking about assigning reversers to 3 different pots and I was told it would work.

I'm currently building a B-727 throttle quadrant ( not quite done yet) that implements the Plasma_lite V2 card. This allows for 8 axis's. 3 throttles ,3 reversers, 1 for speedbrake, and 1 for flaps.

PICTURES! We want pictures!

I'm using the B.I. MM2 interface for mine.

The MM2 Card I`m using that and it is a real Beauty and Leo Lacava is amazing support !!! Excellent interface!

Roberto