A320 FMGS B40

Hi Jeehell, thanks indeed for the quick reply, I've done the update with the updater and all skalarki modules are perfectly working again.
Great software.
Best regards.
Ben

Hello JH , tanks:) what is promise of fscockpit? Sory my english:) but i don't understand. My vrinsight modules will work...right? Cheers
Frederico

I Went to the vrinsight homepage and my hardware connect to jeehell via FSCUIPC. It,S ok?
Fred

As I said already

Quote:

---

Originally Posted by jeehell

If these modules use FSUIPC, it should not be an issue.

JL

---

Hey Jl,

made the update to your last Version and flew a short leg on IVAO...
All works very nice and perfect! Amazing work! Have so much fun on my flight!
Big Big thank you for your hard work!
Did you have maybe some news about Navigraph? ;)

Cheers Florian

Hello Jeehell, I have now an issue with Skalarki ECAM panel, I cannot change systems pages while acting on pushbuttons and I have no green light of system selected...Do you know what could it be?
All my best.
Ben

hi jl,
just made a circuit after latest autoupdate after b40:
all skalarki hw is ok BUT ecam control panel leds are not working; buttons are sending right inputs only leds are not lighting up...asked marcin and he said he didn't touch anything there that's why i'm reporting this to u.
also SD acted strange...during approach sometimes ENG page was displayed randomly...replacing wheel page with no reason. moreover on SD during the entire flight G.LOAD 0.0 was displayed in amber: is that correct? it was not displayed in the past and from what i know it should only be displayed if a certain G load is reached.
thx a lot
fil

Hi,

Hi how is Skalarki ECAM panel working exactly? Does it send pushed and released events?
I'll have a look when I get the time.
JL

yes jl: separate PUSH and RELEASE events in skalarky profiler.
i think buttons inputs were sent correctly...only leds missing....now that ben reported the missing inputs i start doubting i flew such a small amount of time i couldn't get aware of it.
btw in the past with same profiler events everything was rock solid working...
regards
fil

Thank you JL for this version.
The new 1.15 version of CPFlight FCU is working perfectly :)
Always seen G.LOAD 0.0 on SD, but never mind...