Are you sure the Release event is not taken into account?
As far as I can see in my code, the 3 events should work correctly. I'll try it.
Printable View
Are you sure the Release event is not taken into account?
As far as I can see in my code, the 3 events should work correctly. I'll try it.
If I in the new interface set the ENG1MASTER (or 2) to event Release, the next time I press the button the system has reset that to push, as if the release event is unknown.
Just tried, the ENG1MASTER and ENG2MASTER work correcly iether with Push/release events or only one with toggle
By the way, if you use toggle, only ONE position of the physical switch must be used. If you assign the toggle event on the push, and the release event on the release, then ultimately this will not work correctly.
Please post a screenshot of the SW configuration window
It is still an issue here.
See the short video I have uploaded:
http://youtu.be/6KaavPp_ofQ
I set them as push and release, but when I reopen, they are both Push.
/Stephen
should be corrected with new autoupdate.
JL
Yep - solved.
Super!
Jean Luc,
I have today tried to program a push / release button for the XPDR_ON / XPDR_SBY.
I get no effect out of programming these states.
I can see in the VATSIM vPilot, that the system always considers the transponder to be in Mode C, and that this info comes from the FMGS software.
Could you check that the Transponder status is sent correctly please?
Thanks.
Hi
Honnestly this is not a high priority issue. I cannot provide support for every single addons.
However, this should be working with FSUIPC support running for my software.
Regards
JL
Also, if you use two different actions you have to use only the push event.