Hey Ben, thanks for the reply, I was actually asking about this connection. http://www.mycockpit.org/forums/atta...id=12509&stc=1
Printable View
Hey Ben, thanks for the reply, I was actually asking about this connection. http://www.mycockpit.org/forums/atta...id=12509&stc=1
Difficult to find the sirio panel connectors (I haven't found any on sale) - if you have some female canon plug wires lying around you can try and plug one end in, and contact the outer metal part with the other.
Alternatively just plug it into the socket it is suppose to go to and connect to the pins using dupont connectors.
Ben,
thanks for the reply, I did test the bulbs and have some that are not working, just wondering if you used any specific kind of bulb to replace them? Thanks
Jose
Have a read here - https://soarbywire.wordpress.com/builder-notes/
Thanks Ben, I will place an order for replacement bulbs today!!!
Solenoid Lock now implemented using Arduino, Mobiflight, and a relay board:
http://www.youtube.com/watch?v=NP-FKekLYHo
I've written up a short tutorial on how to get the solenoid working with Arduino and a relay switch -
http://www.soarbywire.com/2017/11/13...solenoid-lock/
Thanks Ben!!! bulbs have been ordered and should get them sometime today, i only needed 3 since one of the glarewings was operational.
Hi again, sorry for asking again but I ordered the bulbs for my panel, but they are smaller than the ones already there. In the pic I show the difference between both. I ordered the T-1 7152 5V 115mA 11-10980 (#7152 Miniature Bead Grain of Wheat Bulb 5v); But do I need the #680 Minature Bead Grain? Thanks!!!
Or will those work?
http://www.mycockpit.org/forums/atta...id=12522&stc=1http://www.mycockpit.org/forums/atta...id=12521&stc=1