A320 FMGS B42/43

Quote:

---

Originally Posted by filippoporcari

strange antonio...
...no autoland blinking in my setup...sounds like a local problem
fil

---

Maybe , the problem occours only with CockpitSonic FCU ..

Quote:

---

Originally Posted by asessa

Hi , i'm using B43 and i have the AutoLand korry switch is always blinking (cpt side)... why ?

---

Have you wired up both the captain and FO autoland side?

I noticed with my setup, when only the FO side was wired up, it would blink on FMGS startup.

After I wired up the captain autoland side all was good.

Hi Ben, i've a single seat (cpt) home cockpit and i didn't have this problem with B42 .
For me it isn't a big problem anyway

i've try insterting flightplan using navigraph updated database
but why plane speed and altitude not follow that flpn ?

Hi,

is it OK that after pressing speed, heading and altitude knob on FCU, the heading number remains there? I would expect to see 3 dashes as it does for speed and V/S:

http://www.mycockpit.org/forums/atta...id=10887&stc=1

I have entered a complete route without discontinuities and filled out all necessary pages on MCDU.

Thanks
Stefan

Depends on where and when you pushed the HDG selector. Pressing means arming, it engages only if in the right circumstance, and it then goes to dashes.

JL

anyone seen ils blinking on FD while approach ?

Quote:

---

Originally Posted by stefangr

Hi,
is it OK that after pressing speed, heading and altitude knob on FCU, the heading number remains there? I would expect to see 3 dashes as it does for speed and V/S:
I have entered a complete route without discontinuities and filled out all necessary pages on MCDU.
Thanks
Stefan

---

Hi
This happens to me too after 42.1 or 43 update. I think during "before start checklist", it should be dashed.

Quote:

---

Originally Posted by jeddmc

anyone seen ils blinking on FD while approach ?

---

Turn on the LS button

Quote:

---

Originally Posted by Leonidas

This happens to me too after 42.1 or 43 update. I think during "before start checklist", it should be dashed.

---

I just checked again. The dashes come up during T/O roll when thrust levers are moved into FLEX or TO/GA. I did not notice these dashes coming up then, and - as you said - it must have changed recently.

Thanks
Stefan